top of page

Fabrication and characterization of bio-based polyurethane foams reinforced with natural fillers (two year research thesis)

Problem Statement

With rise in global regulations to conserve the environment, there is a growing need to develop more sustainable polyurethane foam based products. Moreover, micro plastics and synthetic fillers have caused harm to living organisms and so, there is an increasing need to replace them. Consequently, this project was focused on improving the mechanical properties of bio-based polyurethane foam embedded with natural fillers such as cellulose and polysaccharides. 

Due to pending patents, information on which natural fillers were used or which chemicals were selected to make the foam have not been mentioned.

Process to make polyurethane foam
Objectives

This project was divided into three main objectives or studies, as follows:

  • Firstly, four natural fillers were selected and used to fabricate free-rise foam using renewable resources. The mechanical and morphological properties were measured to analyze matrix-filler compatibility

  • Secondly, knowing that the natural fillers from study one showed good compatibility, closed-molded plaques were fabricated, which uses a different pressurized system to cure foam.

  • Lastly, the current formulation used to make polyurethane foam was altered with cross linkers, chain extender, and glycerol, in order to see how these additives improve the mechanical properties of foam

Conclusions

The studies showed improvements in the tensile strength and foam resilience when natural fillers were added to polyurethane foam. Additives including silica (cross linker), glycerol, and chain extender showed high tear strength.

Screen Shot 2020-04-18 at 1.31.38 PM.png
Dog-bone sample being tested to measure the tensile strength (MPa) and ultimate elongation (%) of polyurethane foam
Design of experiment analyses, showing the effects of adding or removing different additives on polyurethane foam mechanical properties (a) tensile strength (MPa), (b) ultimate elongation %, (c) resilience % (d) tear strength (N/mm)
bottom of page