top of page

Resilience Tester

It is known that foam resilience is critical in evaluating the comfort level of foam. For one of my projects, I was interested in measuring foam resilience. The test involved dropping a metallic ball from a height of 500 mm and measuring the height it bounced back up to. 

One of the challenges I faced when setting the structure up was to ensure that the ball did not rotate or hit the tube wall upon drop. To counter this, the magnet was bolted onto a black holder (shown in the picture on the right) with a small spacing drilled at the bottom allowing the ball to sit in place inside when the magnet was turned on. Additionally, purple holders (bottom left) were 3D printed to hold the plastic tube in place at a 90 degree angle and ensure accurate readings. The tube was scribed with markings spaced at 5mm, using a lathe.

​

ResiliencePic2.jpg
ResiliencePic1.jpg
Machined ball holder (in black) with magnet bolted at the top (in red)
IMG_20200208_162725.jpg
IMG_20200208_162657.jpg
3D printed holder to keep tube straight, 5mm wide scribes made on tube using lathe machine at the University of Toronto machine shop
Testing the resilience of a foam block that was fabricated in the University Smart and Adaptive Materials Laboratory
CAD drawing used for 3D printing of resilience test holder
bottom of page